|
|
- Remove heater from package
- Lay pad on decking - avoid seams between decking boards If near left or right side it is easier to replace later
- Locate pad near foot of bed
- Run wire through corner gap at top of decking, controller goes through too.
- Attach controller to side of bed with screws.
- DO NOT PLUG in Heater until mattress is filled with water
- Drain some water and fill with WARM WATER in Winter and don't forget waterbed conditioner.
No heater can heat 1500 - 2000 pounds of cold water in Winter from a cold start.
Dial Setting |
Temperature |
1 |
70 degrees |
2 |
75 degrees |
3 |
80 degrees |
4 |
85 degrees |
5 |
90 degrees |
6 |
95 degrees |
7 |
100 degrees |
|
