security privacy contact cart home
waterbed supplies, waterbed accessories

Waterbed Heaters, Waterbed Accessories for Wood Frame Waterbeds

 

calesco install 1
  1. Remove heater from package and unroll

  2. Lay pad on decking - avoid seams between decking boards

  3. Locate pad near foot of bed






  4. Run wire through corner gap at top of decking

  5. Run sensor wire from controller - at least 12 inches away from heater pad

  6. Plug heater pad into controller







  7. Mount controller on frame using two screws provided

  8. Do Not plug heater power cord into wall socket until mattress is filled





waterbed heater controller closeup

mount controller


Install safety liner and fill mattress with water before plugging heater control into wall socket.

WARNING - Do NOT fill mattress in Winter with Cold Water

No waterbed heater has enough power to heat over 1,000 pounds of cold water up to temperature. Drain some water and fill it back up with very warm water. Remember to add waterbed conditioner as well.

 


filling     

   
  1. Plug controller into wall socket
  2. Middle button is on/off switch
  3. Up and Down buttons change temperature
  4. Numerals flash until temperature is reached.